S355 structural steel plate is a high-strength low-alloy European standard structural steel covering four of the six "Parts" within the EN 10025 - 2004 standard. With minimum yield of 50,000 KSI, it meets requirements in chemistry and physical properties similar to ASTM A572 / 709.
EN 1.0038 Steel S235JR Material Equivalent, Properties EN 10025 S235JR material (1.0038 steel) is an European standard hot rolled non-alloy structural steel grade. It has good plasticity, toughness and weldability, certain strength and good cold bending properties. For specification, datasheet and equivalent, please see the following tables. Material S235JR meaning (designation):
EN Standard S275 Structural Steel Plate S275 structural steel plate is a formable and strong structural steel used for a variety of applications. Overview:Common carbon structural steel that can be bolted, riveted and welded in a full range of construction and fabrication including bridges and other general structural projects.
EN Standard S355 Structural Steel Plate - Leeco Steel LLCHigh-strength non-alloy structural steel used in a variety of structural fabrication applications including bridge components, components for offshore structures, power plants, mining & earth-moving equipment, load-handling equipment, and wind tower components. Meets European structural steel standard
Hot Rolled Channels Taper Flange Channel Harris Hot rolled channel, commonly referred to as parallel flange channels, taper flange channels and U channel is a versatile low cost, low carbon product suitable for a wide variety of applications. The product is mainly used flat in the U orientation or vertically against another structure (wall/steelwork) giving maximum support to the section to
Aug 23, 2015 · S355 is named based on it's minimum yield strength of 355 Mpa (N/mm2), However the yield strength reduces when you go up in thickness above 16 mm for flat products & hollow sections. Here is the table showing reduction in yield strength based on thickness. Up to 16 mm - 355 Mpa. 16 mm < t 40 mm - 345 Mpa.
STRUCTURAL STEEL SECTION FACTOR General GuidelinesTable 8. Japanese Wide Flange Beams (H Section) 30-31 Table 9. Channels with parallel flanges (UPE Section) 31-32 Table 10. European Channels (UPN Section) 32-33 Table 11. Parallel flange channels (PFC Section) 33 Table 12. British channels with taper flanges (CH Section) 34 Table 13. American standard channels (C Section) 34-35 Table 13a.
Table of material properties for structural steel S235 Nominal values of structural steel yield strength and ultimate strength. For structural design according to Eurocode 3 (EN1993-1-1), the nominal values of the yield strength f y and the ultimate strength f u for structural steel are obtained as a simplification from EN1993-1-1 Table 3.1, which is reproduced above in tabular format.